Leave us a message
View larger
New product
Our generators are provided with automatic drainage system in order to reduce the formation of scale and agglomeration of limestone, but this system does not avoid regular maintenance of the unit.
A limescale filter can avoid you a too frequent maintenance of the unit, you can also use a water softener or filter anti Tartar and anti limestone (right photo) (available on our web site - click on the image)
The water in the tank causes an accumulation of limestone more or less quick depending on your water quality, which can subsequently lead to the malfunction of the probe of water as well as accelerated wear of the resistance level.
To perform the cleaning depends on the quality of your water and the frequency of use of the device.
Descaling is recommended every 100 to 200 hours of use (it also depends on hardness and the quality of your water).
-Check that the generator is cold (let it cool if necessary)
-Make sure that the generator is powered - off electricity cut off
-Remove the top plate and side plate (6/8 screws)
-Disconnect the sheets of water level (circular block with 3 causses - see instructions) probe note their position in order to facilitate reassembly
-Unscrew the level sensor and remove the generator using a clamp.
-Clean the probe separately
-Pour the citric acid (citric acid is completely biodegradable and non-toxic) in the tank through the opening of the level probe
-Screw back the level sensor and reconnect the sheets in the same order as the one where you found their disconnection
-Connect the generator to your electrical power
-Operate the generator 2 hours
It is better to drain the device in a container opened in order to see the amount of limescale removed!
Increase the frequency of descaling or decrease the depending on its result
Careful not to put water or citric acid on electrical connections!
Select using the drop-down your steam generator Be very easily replaced by unscrewing the piece, and helps regulate the heater setting and stop time
Round Resistance heaters for steam generator allows you to replace the resistance of your device in case of wear or malfunction Check your model to select the right reference
Allows the replacement of the valve of your steam generator water evacuation (non-contractual photo)
Choose your model using the menu
Probe cable alternative for steam generator Check the brand or the desired model or contact us to know the brand of your device
Electronic card replacement for Desineo or Steamplus steam generator Please make your selection using the menu pulldown
